DICENTIS
Meeting application | en
67
Bosch Security Systems B.V.
Configuration manual
2021.06 | V3.7 |
–
In 2
Sets the sensitivity of Line/Dante
TM
/OMNEO input 2.
–
Out 2:
Sets the sensitivity of Line output 2.
–
In 2
/
Out 2
mode selection menu: Defines the mode of Line/Dante
TM
/OMNEO input 2
and Line/Dante
TM
/OMNEO output 2. Click the arrow on the drop-down list to choose
between:
LSP:
When selected, allows the audio from the delegate’s loudspeaker to be
amplified by an external system.
Recorder (Int. floor):
When selected, allows the audio to be recorded or sent to
interpreters.
Mix - Minus:
When selected, prevents acoustic feedback when two systems are
connected for example via telephone coupler.
Insertion:
When selected, allows an external system to process/equalize the audio.
Unprocessed:
When selected, receives / sends the unprocessed audio (also referred
to as dry signal) from
In 2
/
Out 2.
–
Acoustic Feedback
:
–
No Acoustic Feedback Suppression
(AFS)
:
Off, sets the AFS function to “off”.
–
Natural speech Acoustic Feedback Suppression:
Sets the AFS function to “on” and
selects the natural algorithm for speech.
–
Maximum Acoustic Feedback Suppression:
Sets the AFS function to “on” and
selects the maximum algorithm for speech, which reduces the risk of acoustic
feedback (howling) at higher system volume levels.
Note:
Audio artifacts might occur at higher volume levels.
–
Loudspeaker is active when microphone is on:
Enables the loudspeaker of the
device, when the microphone is on.
–
Attenuate headphone when speaking by
x
dB
: x can be set using the textbox or the
slider. The range of x is 0 dB up to 12 dB. Attenuates the headphone volume of the
device, when the microphone is on.
–
Mute:
When selected, mutes the Line Input / Output or Dante Input / Output. There are
separate mute buttons for
In 1
/ Out 1
and
In 2
/
Out 2.
–
Test Tone:
To test the audio in the system. Select either
Off
,
1 KHz
, or
Sweep
.
Note:
When a
Test Tone
option is selected the
Test Tone
checkbox appears in the
System
and
Line Input / Output
fields
.
–
Headroom:
When
Unprocessed
is selected, the headroom can be set for the Line 2 and
Dante 2 outputs. The range is from 3 dB up to 30 dB.
Headroom
is the buffer you have
against transient peaks or loud sounds before the system goes into clipping.
Refer to
–
Configuring Dante™ compatible devices, page 121
–
Audio routing settings, page 67
5.4.6
Audio routing settings
The following options are available for the audio routing:
–
LSP:
Use this mode if you want audio output 2 of the Audio processor and powering
switch to transmit a signal that can be connected to an external public address system.
The Audio processor and powering switch sets:
–
volume signal level.
–
audio equalization.
Audio input 2 signal of the Audio processor and powering switch is added to the floor
signal.
