en
Familiarising yourself with your appliance
6
Familiarising yourself with your appliance
Familiarise yourself with the parts of your appliance.
Controls
The controls are used to configure all functions of your
appliance and to obtain information about the operat-
ing status.
Switching the appliance on or off
Switching automatic mode on or off
Switches on fan setting 1.
Switches fan setting 2 on.
Switches on fan setting 3.
Switching on intensive mode 1
Switching on intensive mode 2
Switching on the fan run-on
Resetting the grease filter saturation indicator
Resetting the odour filter saturation indicator
Switching the lighting on or off/
Setting the brightness
Basic operation
You can find out everything you need to know about
operating your appliance here.
Switching on the appliance
1.
Pull out the filter pull-out.
2.
Press .
a
The appliance starts at fan setting 2.
Switching off the appliance
1.
Press .
2.
Slide in the filter pull-out.
Selecting a fan setting
▶
Press , or .
Note:
When the filter pull-out is pushed in, only fan set-
tings 1, 2 and 3 can be selected.
Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
1.
Press
to switch on the intensive setting 1.
2.
In order to switch on the intensive setting 2,
press
.
a
After approx. six minutes, the appliance automatic-
ally switches to a lower fan setting.
Switching off intensive mode
▶
Press , or .
a
Intensive mode is ended early.
Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press or slide in the filter pull-out.
a
The appliance switches off automatically after ap-
prox. 10 minutes.
Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
▶
Press .
Switching off automatic mode
▶
Press , , or .
a
The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a
Automatic mode runs for a maximum of four hours.
Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press .
Setting the brightness
▶
Press and hold until the required brightness is
reached.
Switching on the audible signal
Requirement:
The appliance is switched off.
▶
Press and hold and
at the same time for
approx. three seconds until a signal sounds.
Switching off the audible signal
Requirement:
The appliance is switched off.
