Bosch CMG676B.1A, User Manual

Page: 38 / 44

en
Installation instructions
38
Food Accessories/cook-
ware Shelf posi-
tion Heating
function
→
Page 10
Microwave power
setting in W Cooking time
in mins
Sponge Uncovered cookware 1 ⁠ 600 7–9
Meat loaf Uncovered cookware 1 ⁠ 600 22–27
Recommended settings for cooking in combination with the microwave mode
Food Accessory/cook-
ware Shelf pos-
ition Heating
function
→ Page 10
Temperature in
°C Microwave
power setting
in W Cooking
time in
mins
Potato gratin Uncovered cook-
ware 1 150 - 170 360 25 - 30
Cakes Uncovered cook-
ware 1 190 - 210 180 12 - 18
Chicken Uncovered cook-
ware 1 180 - 200 360 25 - 35
1
1
Turn the dish 2/3 of the way through the cooking time.
26 Installation instructions
Observe this information when installing the appliance.
26.1 General installation instructions
Follow these instructions before you start with
the installation of the appliance.
¡
The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35 mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.
¡
Ventilation slots and intake openings must
not be covered.
¡
The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡
Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡
Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡
Proceed in accordance with the installation
sheets for installing accessories.
¡
Fitted units must be heat-resistant up to
95 °C, and adjacent unit fronts up to
70 °C.
¡
Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.
¡
Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡
The mains socket for the appliance must
either be located in the hatched area or
outside of the area where the appliance is
installed.
Any unsecured units must be secured to
the wall using a standard bracket ⁠.