CIP5000 series storage
Hardware configuration | en
25
Bosch Security Systems B.V.
User manual
2019-10 | V01 | F.01U.380.030
Counter-sink screws
(two screws on each side)
Figure
5.10: SATA disk drive mounted in a drive carrier
5.4
Management path connection
This section describes how to establish a management connection for the CIP5000
subsystems.
Through the management GUI - a web browser based GUI, you can finish to configure
management path connection.
There are two 1 Gb/s Ethernet RJ-45 ports on the rear panel for connection to an Ethernet
network. After logging into the Management GUI as the administrator, you can change the
network settings.
To connect the server to a local Ethernet for management:
1.
Attach one end of an Ethernet cable to the network connector or standard NIC in the
Host PC. Attach the other end of the Ethernet cable to one of the ports on the standard
network switch.
2.
Attach one end of an Ethernet cable to one of the ports on the standard network switch.
Attach the other end of the Ethernet cable to an Ethernet port (1000 BASE-T) on the back
of the server.
If you have more than one CIP5000 system, host, or server, repeat steps 1 and 2 as instructed.
5.4.1
SAS JBOD expansion
JBOD expansion requires:
–
One or more CIP-5316-JBOD expansion cabinets
–
One cable from SFF-8644 to SFF-8644 SAS for each CIP-5316-JBOD
Connect to JBOD data path
The SFF-8644 SAS expansion port connector is located on the rear panel of the CIP5000
subsystems (CIP-5316W-00N or CIP-5424W-00N). The controller of the CIP5000 subsystems
manages the CIP-5316-JBOD system, and no additional management connection is required
for the CIP-5316-JBOD system.
Summary of Contents for CIP-5316-JBOD
Page 1: ...CIP5000 series storage CIP 5316W 00N CIP 5424W 00N CIP 5316 JBOD en User manual ...
Page 2: ......
Page 67: ......
