1 691 606 210
2015-07-29
|
Robert Bosch GmbH
48 | BSA 43xx | Manual mode (normal operation)
en
5.
Manual mode (normal
operation)
i
Manual mode is required for the performance of
single wheel measurements.
Principal features:
R
Test sequence can be selected by user.
R
Measurements must be started manually.
R
Measurement results can be stored.
R
Measurement results can be printed out.
R
Single wheel measurements are possible.
R
Suitable for four-wheel drive vehicles.
5.1
Mode activation and deactivation
Manual mode is the standard factory default setting.
Following termination of other modes, the BSA 43xx re-
turns to manual mode.
5.2
Test sequences
5.2.1
Vehicles test routine
i
The weight is required for calculation of deceleration. The weight can be entered or measured as follows:
$
Manual entry using remote control unit (refer to Section 5.3.1).
Manual weight entries have precedence over measured weight values.
$
Axle load scales in brake dynamometer (special accessory).
Use is automatically made of the measured weight if the weight has not been entered manually.
$
Manual transfer of weight from suspension tester (refer to Section 5.2.2, step 3).
Step
Remote control unit
Result / Display
1.
Check prerequisites:
R
No vehicle on brake dynamometer!
R
Tester/test routine selected.
Left: "Brake dynamometer" device symbol.
Right: Drive-on prompt.
2.
Drive onto the brake dynamometer
with the axle to be measured first and
keeping the vehicle
straight
. Disengage
gear. Release brake pedal.
!
If the vehicle is not straight on the set
of rollers, it will slide off to the side.
Counter-steer until the vehicle returns
to straight position on the set of roll-
ers. Measurement is not to be started
before this has been done.
It may be necessary to drive off the set
of rollers and then drive the vehicle
back on.
Axle to be measured is positioned on set of
rollers.
If axle load scales are being used (special
accessory): The axle load in kilograms appears
on the screen.
