• Do not use EMERGENCY STOP controls for routine stopping.
• Regularly check the EMERGENCY STOP controls to ensure that they are
functioning properly.
• Following an EMERGENCY STOP or in the event of a fault or other irregularity,
turn the product off and secure it against being switched back on.
• Do not reach into moving parts.
• An idle system is not necessarily a safe system, as stored energy can be released
unintentionally or through improper maintenance procedures.
• After an EMERGENCY STOP or a malfunction, only switch the system back on once
you have established and rectifi ed the cause of the fault.
• Make sure that access to maintenance and inspection points is kept unobstructed.
• Perform the prescribed maintenance use at the intervals specifi ed in
chapter 10.3 "Maintenance".
• Make sure that no line connectors, connections or components are disconnected
as long as the system is supplied with pressure and voltage. Secure the system
against being switched back on.
• Dispose of the product in accordance with the regulations in your country.
2.7 Personal protective equipment
• Appropriate protective clothing should be worn when handling/using the product
(e.g. safety shoes, close-fi tting clothing, a hair net for long, loose hair).
As the system owner or operator, you are personally responsible for ensuring the
use of appropriate protective equipment when the product is being used.
All component parts of the personal protective equipment must be free of damage.
2.8 Owner
responsibilities
• Before the initial commissioning or re-commissioning of a conveyor system,
carry out a risk assessment in accordance with DIN EN ISO 12100.
• Before initial commissioning, make sure there are no protruding or sharp-edged
parts that may be a hazard to personnel working or moving in the area.
• Provide safety-related instructions to the operating personnel before initial
commissioning or re-commissioning, and then at regular intervals.
3 General notes on property and
product damage
The warranty only applies to the delivered confi guration.
• The warranty is void in the event of incorrect assembly, commissioning and
operation, as well as improper use and/or improper handling.
• The following safety information applies to sections 6 to 14.
• Ensure that the conveyor chain is lubricated suffi ciently, see page 43.
– Keep a maintenance schedule.
– Keep degreasers or aggressive cleaning agents away from the conveyor chain.
EMERGENCY STOP,
malfunction
During servicing and repair
During disposal
During operation
General notes on property and product damage
11/84
3 842 563 834/2022-08, MIT: BS 2/C-…, BS 2/R-…,
Bosch Rexroth AG
EN
GLISH
