58300000187895 ARA EN A
MAY 2015
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Page 26 of 36
Copyright by BSH Home Appliances Corporation
1901 Main St
▪ Suite 600 ▪ Irvine, CA 92614
800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
Figure 29 Rest the maintop to remove 12 screws (3 on each side)
Figure 30 Inductors and display board are accessible after removing maintop
8 SERVICE AND REPAIR: COOKTOP
8.1
Replacing the Maintop
1. Disconnect power to the range, and slide it out from the cutout.
2. Remove the 5 screws securing the rear vent trim.
3. Remove the 4 screws securing each side of the ceramic maintop
assembly.
4. Grasp the rear of the maintop with both hands and slide it toward
the rear, angling it slightly upward to disengage the maintop from
beneath the lip of the front panel.
5. Rest the maintop as shown below, and remove the 3 screws on all
four sides, which secure the internal frame to the ceramic
maintop.
6. Carefully lift the maintop away from the internal frame; the
element covers, induction sets beneath them, and the display
board and its support will be accessible.
7. Install the new maintop and reassemble.
8. Restore power and test operation.
9. Slide the range back into place, being sure to properly engage the
anti-tip bracket.
8.2
Additional Information
For additional information about the operation of the induction
cooktop, please refer to the cooktop Repair Instructions (and videos)
that are linked to HIIP054C and HIIP054U in
QuickFinder
.
WARNING
To avoid possible electric shock, be sure electrical supply to the
range is turned off before servicing.
If testing the appliance requires the use of electrical power, exercise
extreme caution.
!
