58300000187895 ARA EN A
MAY 2015
Service Manual for Bosch Benchmark Series Induction Slide-in Ranges
Page 20 of 36
Copyright by BSH Home Appliances Corporation
1901 Main St
▪ Suite 600 ▪ Irvine, CA 92614
800 944-2904
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
Figure 22 Removing the glass lens
1. Remove the control panel as described in
Replacing the
Control Panel Assembly
section.
2. Using pliers, straighten each of the metal tabs securing the
board so that they align with the slots in the display board,
then lift the board off the carrier tabs.
3. Position the new display board so that the slots in the board
align with the four metal tabs, and firmly push the board
downward until it is securely in place.
4. Slightly twist each of the four metal tabs to secure the board to
the carrier.
5. Reassemble the control panel and re-attach all wires.
6. Reattach the control panel to the range.
7. Restore power and test operation.
7.5
Cavity Lights
Each oven cavity uses two incandescent 40W appliance bulb with a
standard Edison base (E26). Replacement bulbs may be purchased
locally if not available from Bosch.
The cavity lights can be turned on in two ways: by pressing
Oven Light
or opening the oven door. If
Oven Light
had not been pressed to turn
light on prior to opening the oven door, the light(s) will turn off when
the door is closed. If
Oven Light
had been pressed to turn light on prior
to opening the oven door, the lights will remain on after the door is
closed. In other words, the
Oven Light
switch overrides the door.
7.5.1
Replacing a Lamp
1. Unscrew glass lens cover by turning it counter-clockwise.
2. Unscrew the appliance bulb by turning it counter-clockwise.
3. Insert the new bulb.
4. Replace the glass cover.
5. Restore power to the unit and test the operation of the light.
7.6
Convection Fan, Ring Element and Motor
All Benchmark series slide-in ranges have a Euro-convection cavity
with a fan and ring element on the rear cavity wall.
Depending on the cooking mode selected, the fan may be used, with
or without the ring element, to circulate heat evenly throughout the
cavity. The 240V 2000W ring element, however, will never run without
the fan.
The fan blade is easily accessed on the rear wall of the oven cavity
behind the convection baffle. It is likely that the wires to the ring
NOTICE
Sometimes, after running a self-clean cycle at high heat, it may become
difficult to remove the glass lens. If it cannot be done by hand, an
adjustable strap-wrench may be used.
CAUTION
Turn off power to the range at the fuse or breaker box: light
socket is live with door open.
Be sure oven and lights are cool to the touch.
Handle glass lenses and glass bulbs carefully.
