Troubleshooting
en
19
16.9 Cleaning the control panel
ATTENTION!
Incorrect cleaning may damage the control panel.
▶
Never wipe the control panel with a wet cloth.
1.
Read the information on cleaning products.
2.
Clean the control panel using a microfibre cloth or a
soft, damp cloth.
3.
Dry with a soft cloth.
17 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
17.1 Malfunctions
Fault
Cause and troubleshooting
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Malfunction
1.
Switch off the fuse in the fuse box.
2.
Switch the fuse back on after approx. 10 seconds.
a
If the fault was a one-off, the message disappears.
3.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→
Microwave not work-
ing.
Door is not fully closed.
▶
Check whether food remains or foreign material are trapped in the door.
Food does not heat
up; lights up
on the display.
Demo mode is activated in the basic settings.
1.
Disconnect the appliance from power supply by briefly switching off the circuit breaker in
the fuse box.
2.
Go to the basic settings and deactivate Demo mode within the next 5 minutes.
→
The interior lighting is
not working.
Different causes are possible.
▶
Call the after-sales service.
→
Microwave mode is
cancelled.
Malfunction
1.
Reset appliance.
‒
Either press and hold for at least 6 seconds.
‒
Or switch off the circuit breaker or fuse in the electrical panel. Switch the fuse back
on after approx. 10 seconds.
a
If the fault was a one-off, the message will disappear.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→
Food takes longer
than usual to heat up.
The microwave power setting is set too low.
▶
Set a higher microwave power setting.
Summary of Contents for BE.7321.1M
Page 31: ......
