![background image](http://html.mh-extra.com/html/bosch/b465/b465_installation-and-operation-manual_38832076.webp)
76
en | System Configuration
Conettix Universal Dual Path Communicator
2017.11 | 05 | F.01U.311.207
Installation and Operation Manual
Bosch Security Systems, Inc.
When the B465 removes voltage from the PNL
LINE
2 terminals (terminals for panel phone line
2), the control panel connected to the terminals creates a phone line failure event or a
communication failure event.
USB Menu Location
[4] System Configuration > [5] Communication Failure Action > [4] Comm Fail removes line 2
phone voltage
8.6
Module Supervision
Use the parameters in this section to configure the B465 to send reports and set the Trouble
LED and output when there is an internal fault (trouble).
8.6.1
Module Faults send reports
Default
:
Enabled
Selections
:
–
Enabled - the B465 sends trouble reports for module faults.
–
Disabled - the B465 does not send trouble reports for module faults.
The B465 sends reports in the Contact ID (SIA DC-05) reporting format.
USB Menu Location
[4] System Configuration > [6] Module Supervision > [1] Module Faults send reports
8.6.2
Module Faults set Trouble Output
Default
:
Disabled
Selections
:
–
Enabled - when there is a module fault event, the B465 sets the system trouble output.
–
Disabled - the B465 does not set the system trouble output for module fault events.
USB Menu Location
[4] System Configuration > [6] Module Supervision > [2] Module Faults set Trouble Output
8.7
RPS Settings
8.7.1
RPS Passcode
Default
:
999999
Selections
:
6 to 24 alphanumeric characters
RPS sends the RPS passcode to the control panel to establish a connection.
Enter a minimum of six characters. Do not use spaces in the passcode. The passcode is case-
sensitive.
USB Menu Location
[4] System Configuration > [7] RPS Settings > [1] RPS Passcode
8.7.2
Answer RPS over Network
Default
: Enabled
Selections
:
–
Enabled - enables automatic RPS initiated connections through the onboard Ethernet
communicator or plug-in cellular communicator.
–
Disabled - prevents automatic RPS initiated connections over the network.
USB Menu Location
[4] System Configuration > [7] RPS Settings > [2] Answer RPS over Network
8.8
USB Terminal Passcode
Default
:
B465
Selections
: 4-23 ASCII characters (no spaces)
Summary of Contents for B465
Page 1: ...Conettix Universal Dual Path Communicator B465 en Installation and Operation Manual ...
Page 2: ......
Page 114: ......