Bosch B30 Series, Installation Instructions Manual

Page: 22 / 124

22
Concrete floor applications
Not recommended for use in light-weight masonry material
such as block or brick.
Not recommended for use in new concrete which has not
had time to cure.
Do not use core drills to drill holes for this anchor.
Use concrete anchor M8 and M8 srew. Additional use the
wooden screws provided, see overview diagram “Use the
screws in the screws set”.
̈
Drill a
13
/
32
" (10 mm) diameter hole any depth
exceeding the minimum embedment. Use the provided
drill.
̈
Clean hole or continue drilling additional depth.
̈
Manually insert the screw into the wall plug until the
screw begins to resist.
̈
Knock the wall plug and screw into the hole until the
screw head is approx.
1
/
2
" (13 mm) from the anti-tip
bracket.
̈
Tighten the screw.
̈
Additionally use the supplied wood screws
(if the subsurface allows).
7. Attaching an alternative anti-tip
device
̈
Saw the wooden beam (cross section min. 3" x 4")
to the required length.
Length is equal to the width of the installation cavity!
m
CAUTION
m
Always wear safety glasses and other necessary pro-
tective devices or apparel when installing or working
with anchors.
Risk of injury!
IMPORTANT NOTE
If the anti-tip brackets cannot be attached securely,
an alternative anti-tip device can be attached.
However, ensure that there is no play between the
appliance and the anti-tip device.
If possible, always screw the wooden beam to existing
studs on the rear panel of the cavity.
NOTE
– If the installation cavity is deeper than the
appliance, select a beam which has a larger cross
section or attach 2 beams.
– The beam must cover the appliance by
at least 2" (50.8 mm).