Bosch AUTODOME IP 4000i NDP-4502-Z12, User Manual

Page: 48 / 78

48 en | Recording AUTODOME IP 4000i
2020-06 | 2.0 | User Manual Bosch Security Systems
!
Caution!
Without metadata, it is not possible to include video content analysis in recordings.
Select what is to be included in the recordings:
–
Audio : If audio is not enabled, Off is shown. Click on Off and the page is redirected to
the Audio section.
– Metadata .
Standard recording
Select the mode for standard recordings:
–
Continuous : the recording proceeds continuously. If the maximum recording capacity is
reached, older recordings are overwritten automatically.
– Pre-alarm : recording takes place in the pre-alarm time, during the alarm and during the
post-alarm time only.
– Off : no automatic recording takes place.
Stream
Select the stream to be used for standard recordings:
–
Stream 1
– Stream 2
– I-frames only
Alarm recording
Select a period for the Pre-alarm time from the list box.
Select a period for the Post-alarm time from the list box.
Alarm stream
Select the stream to be used for alarm recordings:
–
Stream 1
– Stream 2
– I-frames only
Check the encoding interval and bit rates from profile: box and select an encoder profile to
set the associated encoding interval for alarm recording.
Check the Export to account box to send standard H.264 or H.265 files to the target whose
address is displayed.
If the target has not yet been defined, click
Configure accounts to jump to the Accounts page
where the server information can be entered.
Alarm triggers *
Select the alarm type that is to trigger an alarm recording:
–
Alarm input
– Analysis alarm
– Video loss
Select the Virtual alarm sensors that are to trigger a recording, via RCP+ commands or alarm
scripts, for example.
7.4 Maximum Retention Time
Recordings are overwritten when the retention time entered here has expired.
4 Enter the required retention time in days for each recording track.