ARD-AYCE65B
Reader Functionality | en
13
Bosch Sicherheitssysteme GmbH
Installation manual
| V 1.1 | 2009.08
Entering Programming Mode
1.
Press the # key 4 times.
–
Transmit LED will turn off.
–
Program LED will turn red.
2.
Enter your 4 digit Programming Code. If the Programming
Code is valid, the door LED will turn green and the ARD-
AYCE65B will be in Programming Mode.
Exiting Programming Mode
1.
To exit the Programming Mode at any time press #:
–
You will hear a beep
–
The Program LED will be off
–
The Transmit LED will turn red
2.
This indicates that the ARD-AYCE65B has returned to
Transmit Mode.
3.
Wrong entries may reset the reader back to Transmit
Mode.
While in Programming Mode if no key is pressed for 30
seconds the ARD-AYCE65B will exit Programming Mode
and return to Transmit Mode.
5.3
Selecting Keypad Transmission Format
The ARD-AYCE65B has eight different keypad transmission
formats to select from. Follow the steps below to select the
appropriate keypad transmission format that you wish to use.
1.
Enter Programming Mode.
2.
Press "1" to enter.
"The Transmit LED will turn Red.
NOTICE!
–
The factory 4-digit Programming Code is 1234.
–
If a Programming Code is not entered within 30 seconds,
the ARD-AYCE65B will return to Transmit Mode.
Summary of Contents for ARD-AYCE65B
