Bosch 22-15-2061, Translation Of Original Operating Instructions, Page: 121 / 299

MY22Z0a - 12_1.0_25.07.2022
120
Operation
6.5.7 Handles
6.5.7.1 Replacing the handles
Not included in price
If there is pain or numbness in the index, middle
finger or thumb, this may be due to excessive
pressure on the exit of the carpal tunnel. On
longer rides, this can increasingly cause hand
fatigue and make it more and more difficult to
maintain a correct hand position.
In the case of ergonomically shaped handles, the
palm rests on the anatomically shaped handle. A
greater contact surface means that the pressure is
more evenly distributed. Nerves and vessels are
no longer squeezed in the carpal tunnel.
Moreover, the hand is supported and held in the
correct position so that the hand can no longer
bend.
If the pre-mounted handles are uncomfortable or
cause pain or numbness in the index, middle
finger or thumb, ergonomic handles, bar ends or
multi-position handlebars should be used.
6.5.7.2 Adjusting ergonomic handles
Only applies to pedelecs with this equipment
Figure 131: Incorrect (1) and correct (2) position of the
handle.
6.5.7.3 Checking handlebar stability
 See Section 7.5.12 .
Handles with bolt clamps are components which
may be replaced without approval.
§
1 Undo handle clamping screw.
2 Turn handle into the right position.
3 Fasten handle clamping screw with the torque
value indicated there.
 The handles are firmly fastened.

The pull-off force of the handles is at least 100
N in the roadster, city and trekking positions,
and at least 200 N in the sporty position.
1 2
9
_