Bosch 22-15-2061, Translation Of Original Operating Instructions, Page: 134 / 299

MY22Z0a - 12_1.0_25.07.2022
133
Operation
6.5.13.3 ROCKSHOX Paragon Silver coil spring
Only applies to pedelecs with this equipment
1 Put on normal cycling clothing.
2 Ask someone to hold the pedelec.
3 Stand on the pedals. Allow the damper to
deflect three times. Sit or stand on the pedelec
in a normal riding position.
4 Ask your helper to push the O-ring downwards
until it reaches the top of the dust wiper seal.
Figure 144: Moving the O-ring on the suspension fork
5 Get off the pedelec without allowing it to
deflect.
6 Note distance between dust wiper and the
O-ring. This distance is the sag.
Figure 145: Sag (1)
7 Check the sag.
Figure 146: Mandatory sag range (green) and prohibited
sag range (red)
8 If the desired sag is not achieved, the spring
preload must be adjusted inside and/or the coil
spring replaced. Contact specialist dealer.
1
Setting Sag
Prohibited >30%
High sensitivity 20…30%
Low sensitivity 10…20%
Prohibited < 10
Table 42: Recommended sag
Adjusting preload internally
 Only your specialist dealer may make an
internal adjustment to the preload.
Preloading the coil spring on ROCKSHOX
Paragon forks is an internal adjustment that
compresses or decompresses the spring without
changing the deflection.
The coil spring can be preloaded 5 mm or 10 mm
using the internal preload spacer.