Installation & Operation
Initial Set-up
After unpacking the unit, please avoid placing the unit in direct sun light, excessive heat,
excessive humidity or in contact with fluids of any type. Please allow 20cm space around the
unit.
Connect Mains Power
Plug the UPS into an electrical outlet that does not share a circuit with a other heavy electrical
load. Please allow the UPS to charge at least 6 hours prior to use.
Connect Equipment
Connect critical equipment to the battery backup outlets; these are supported automatically by
the battery when a mains failure occurs. Connect other equipment that needs only surge
suppression to the surge protected outlets. Power is not supplied to these outlets when the
unit is switched off. Therefore, please be sure to switch on the unit.
NOTE: Please DO NOT connect scanners or printers to the battery backup outlets.
Connect Modem/Phone/Network for Surge Protection
Connect a single modem/phone line into surge-protected “IN” outlet on the back panel of the
UPS unit. Connect from “OUT” outlet to the computer with another phone line cable.
Connect Communication Port
To allow for unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB port and the other to the communication port of your
PC. With the monitoring software installed, you can schedule UPS shutdown/start-up and
monitor UPS status through PC.
Software Installation
1) Please download the monitoring and shutdown software from the website
http://www.borri.co.uk/softwaredownload
to download ViewPower software.
2) When your computer restarts, the monitoring software will appear as an orange plug icon
located in the system tray, near the clock.
Power On/Off UPS
Press power switch on the front panel of the UPS to turn on the UPS. Press switch again to turn
off the UPS.
Front Panel & Back Panel
LCD panel
Power switch
B200-1000
B200-1500/2000
Troubleshooting
Problem
Possible Cause
Solutions
The front panel in blank.
Low battery.
Charge the UPS at least 6 hours.
Battery fault.
Replace the battery with the same
type of battery.
The UPS is not turned on.
Press the power switch again to turn
on the UPS.
Alarm sounds
continuously when the
mains is normal.
The UPS is overload.
Remove some loads first. Before
reconnecting equipment, please
verify that the load matches the UPS
capability specified in the specs.
When power fails,
back-up time is short.
The UPS is overload.
Remove some critical load.
Battery voltage is too low.
Charge the UPS at least 6 hours.
Battery defect. It might be due
to high temperature operation
environment, or improper
operation to battery.
Replace the battery with the same
type of battery.
The mains is normal but
UPS is on battery mode.
Input power cable is loose.
Reconnect the input power cable
properly.
LCD Panel:
Input voltage
Load level indicator, flashing
Output voltage indicates overload
AC mode indicator
Battery capacity indicator, flashing
Battery mode indicator indicates low battery
Battery backup receptacles
Surge protected receptacles
AC input
USB communication port
Modem/Phone Line/Network
surge protection