12
User guide
Rayplicker Cobra
4.
FIRST START-UP
4.1. Fitting the calibration tip
The calibration tip is positioned (clipped)
at the end of the measuring head. Thanks
to its specific design, it can be supported
on the patient’s teeth, thus ensuring precise
positioning of the device.
It incorporates a chromatic reference (gray
pattern) necessary for the proper functioning
of the device through a self-calibration step
not perceived by the user.
It is necessary to ensure that the calibration
tip is clean and in good condition. It must also be protected from the sun’s rays and any other
type of external aggression. The condition of the tip attests to the quality of the calibration and
guarantees the quality of the data collected by the Rayplicker Cobra. We invite you to check
the condition of your tips, for this, please refer to the protocol for use of the Rayplicker Cobra
present on the BOREA website.
4.2. Device charging
Before its first use, the device must be charged.
Charging can take up to 4 hours. To do this, the
device must be placed on its base and then
connected using the cable to a mains socket.
When the device is charging, the base flashes
blue. Once charged, the base turns off.