EN
136
Installation
www.bora.com
Height adjustment plates for flush installation
(optional)
1
2
Fig. 10.28
Height adjustment plates
[1]
Cooktop
[2]
Height adjustment plate
1
2
Fig. 10.29
Height adjustment plates
[1]
Sealing tape
[2]
Optional height adjustment plates
O
The height adjustment plates are self-adhesive to
prevent slipping during installation.
X
If applicable, insert the height adjustment plates [2].
X
Place the height adjustment plates next to the
sealing tape [2].
10.7.9 Making a connection with the
back panel (only in installation
variant A)
1
3
2
Fig. 10.30
Connection with the back panel
[1]
Telescopic pull-out
[2]
Adhesive tape
[3]
Back panel of unit
X
Remove the protective film from the adhesive
tape [6] on the front of the telescopic pull-out.
X
Use the inlet opening [2] as a handle during
insertion.
X
Keep the cooktop [1] straight as you lift it into the
worktop cut-out [5]
X
Insert the cooktop [1] into the centre of the
worktop cut-out [5].
X
Precisely align the cooktop.
1
2
3
Fig. 10.27
Securing the cooktop
[1]
Cooktop
[2]
Holding clamp
[3]
Worktop
X
When aligning the cooktop, ensure that the
holding clamps hold the cooktop in the worktop.
Information regarding surface mounting:
X
make sure that the cooktop sealing tape is flat
against the worktop.
Information regarding flush installation:
X
make sure that the cooktop sealing tape is well
sealed all the way round.
