127
Installation
www.bora.com
EN
10.3 Tools and aids
The following special tools, among others, are
required to correctly install the cooktop:
O
compass saw or hand saw
O
drilling template for cut-out on back panel PURU
(included in scope of delivery)
O
Torx 20 screwdriver
O
black, heat-resistant silicone sealant
10.4 Assembly instructions
10.4.1 Required clearance distances
X
Observe the required clearance distances.
1
3
2
Fig. 10.3
Required clearance distances
[1]
Minimum clearance of 50 mm between the
worktop cut-out and the rear edge of the worktop.
[2]
Minimum clearance of 300 mm from the left
and right of the worktop cut-out to the adjacent
cabinet or wall.
[3]
Minimum clearance of 600 mm between the
worktop and the wall unit. A minimum clearance
of 1000 mm is recommended for ergonomic
reasons.
X
If simultaneously operating both a fireplace and the
cooktop extractor in the same room, ensure that:
O
the maximum low pressure is 4 Pa (4 x
10–5 bar);
O
a safety device (e.g. window contact switch,
low pressure warning device) is used to
ensure that a sufficient supply of fresh air is
guaranteed;
O
the exhaust air is not channelled into a
chimney that is used for exhaust gases of
appliances operated with gas or other
combustibles;
O
the installation is checked and approved by
an authorised certified engineer (e.g. heating
engineer).
i
If the cooktop extractor is used exclusively in
recirculation mode, operation with an open
fireplace is possible without any additional
safety measures.
10.2 Scope of delivery
Scope of delivery PURSA, PURSU
Quantity
Cooktop with integrated cooktop extractor
1
Air inlet nozzle
1
Stainless steel grease filter
1
Operating and installation instructions
1
Sealing tape
1
Height adjustment plate set
1
Bag containing various small parts for
assembly
1
Additional scope of delivery PURSU
Activated charcoal filter
1
Template for back panel cut-out
1
Tab. 10.1
Scope of delivery
Checking the scope of delivery
X
Make sure the delivery is complete and check it
for damage.
X
If there are any missing or damaged parts, please
notify the BORA After Sales Service immediately.
X
Do not under any circumstances install parts
which are damaged.
X
Dispose of transport packaging in the proper
manner (see „11 Decommissioning, disassembly
