bora Pro PKG3, Operating And Installation Instructions

Page: 28 / 44

EN
28
Configuration menu
www.bora.com
Menu item
CF
: gas burner characteristic curves
The characteristic curves regulate the minimum gas burner
power values. The minimum power levels are adjusted using the
characteristic curves. Depending on the installation situation
and the influence of the cooktop extractor, if necessary, the
characteristic curve can be changed.
Characteristic curve A:
Characteristic curve A enables the fine tuning of the power
values, which can only be adjusted in the best-case scenario and
only in the case of natural gas (G20, G25, G25.3).
The best-case scenario is when:
X O
no cooktop extractor is in operation; or
X O
the cooktop, when using the cooktop extractor in exhaust air
mode, is used with sufficient ventilation; or
X O
the cooktop, when using the cooktop extractor in recirculation
mode is used with a sufficient return flow aperture and the
cooktop extractor does not have a negative influence on the
gas flame.
Characteristic curve B:
Factory default characteristic curve with balanced adjustment of
the individual power levels.
Characteristic curve C:
Characteristic curve C increases the lower power levels and
should only be used in the event of a negative influence from the
cooktop extractor.
Setting Gas burner characteristic curves
0
Characteristic curve A
1
Characteristic curve B (Factory setting)
2
Characteristic curve C
Tab. 6.3
Characteristic curves for the gas burner
X
X
Select the appropriate characteristic curve.
i
If the gas flame goes out, is excessively affected by the
extractor and/or the flame is not as it should be (e.g.
soot production, flame blowback, etc.), the characteristic
curve must be increased, as well as the ventilation
in exhaust air mode, if necessary, or the return flow
aperture in recirculation mode.
Menu item
Ch
: GPU reset
i
Menu item
Ch
(GPU reset) provides a reset function.
This reset function can be used in the case of faults and
errors and during initial operation if the gas cooktop does
not react (does not ignite).
i
The set values for the gas type, pressure and
characteristic curve remain unchanged and are not
affected by the reset.
Setting GPU reset
0
Resetting a locked GPU
Tab. 6.4 Resetting a locked GPU
X
X
Perform a reset if necessary.