Please read this before using this
Intellimatch product.
IM22 and IM14 Quick Start Guide
Connecting output from IM22/Im14 to servos.
All servos are slightly different. Some servos will handle a reverse polarity and some will not. Therefore it is
extremely important that you connect your servos correctly prior to applying power to the system. The following
pictures show exactly how to make this connection.
Performing the Intellimatch
Matching servos is an easy task once you understand the principles of how the Intellimatch system works. The
following method describes how to get excellent results when matching your servos. Please read and understand the
following before mechanically coupling the servos or applying power.
1) Mechanically match the servos as much as possible then
mechanically disconnect the slave servo.
2) With the slave servos mechanically disconnected from the master servo, set the servo range on your transmitter
with only the master servo connected to the IM22/IM14.
3) With the slave servos mechanically disconnected from the master servo, electrically connect the slave servo to the
output1 connector on the IM22/IM14. NOTE: THE SIGNAL WIRE GOES TO THE TOP WHEN PLUGGING IN SERVOS.
PLEASE ENSURE THE CONNECTOR POLATIY IS CORRECT I.E. THE SIGNAL WIRE IS TO THE TOP.
