Bonnet PRECIJET+ 10 GN1/1, Operating Manual

Page: 12 / 15

3B-390978NU – 10/18 Page 9
EN
BONNET GRANDE CUISINE
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
19 ERROR MESSAGES
Message on the screen Consequences What to do?
i31 : Electronics overheating: Temperature reduced
to 180°C
Cooking continues automatically
at a temperature below 180°C Clean the lower and rear air intakes. If the problem persists, call
a service technician.
i33 : Core probe non function or not plugged Cooking stops To continue cooking connect a probe or switch to timer mode.
E46 : Electronic communication fault (Bus RS485) Cooking stops Possible to launch safe mode: convection mode at 175°C (see
guidance and info about the control screen).
E53 : Motor short-circuit or ventilation non function Cooking stops Switch the oven off and call a service technician.
E61 : Ambient probe short circuit Cooking stops Switch the oven off and call a service technician.
E62 : Ambient probe non function Cooking stops Switch the oven off and call a service technician.
E67 : Gas safety activated Cooking stops Check gas inlet. Switch the oven off and call a service technician.
E68 : Cavity at +290°C Cooking stops Switch the oven off and call a service technician.
E72 : Electronics at over + 75°C Cooking stops Switch the oven off and call a service technician.
i81 : Water flow rate too low Cooking continues.
A cleaning cycle stops (Paused) Check the valve and water pressure.
Switch the oven off and call a service technician.
E82 : Solenoid sticking Cooking continues. Switch the oven off and call a service technician.
USB stick full USB stick is full. Clear the USB stick
USB missing USB stick required Connect a USB stick
20 RECOMMENDED AND FRONT LINE SPARE PARTS
Designation Codes
1 way 1 x 10 L/min solenoid valve 144937
Drive shaft wear ring 145587
2 way solenoid valve, 2 x 10 L/min 147152
Motorised drain outlet 148187
Sub assembly - Gas valve without safety enclosure 148222
Starting electrode 148223
After sales kit 9kW element 340 dia + seal 148752
After sales kit 15kW element 500 dia + seal 148753
After sales kit 9kW element 430 dia + seal 148754
Reed switch 300676
Three-pole 25A 230V 50/60 Hz contactor / Three-pole 32A 230V 50/60 Hz contactor 300697 / 300698
Three-pole 40A 230V 50/60 Hz contactor / Three-pole 50A 230V 50/60 Hz contactor 300699 / 300700
Tree-pole 80A 230V 50/60 HZ contactor 300702
Anti-interference relay 300769
Ultra fast fuse 0.2A 250V 5 x 20 300787
10amp 5 x 20 fuse 300788
2 point PT 100 regulating sensor 301471
1 point regulation probe, PT 100 301485
Axial fan 304194
Condensator 5 µF for pump 304269
Pump with cylinder blocks 230V 50/60HZ 304275
LN2 fixed centrifugal fan 7000rpm 304276
Motor 304292
Condenser 12.5µf 304293
Reducing gear with center return spring, 85 degrees 305108
3 phase 125A fuse holder / 3 phase 50A fuse holder 307468 / 307469
14 x 51 32A GG fuse / 22 x 58 63A GG fuse 307471 / 307472
Switching regulator 15V 15W RS 15-15 308350
Fuse 3.15 Amps 309407
Inter card cable / Inter card cable (2 metres long) 309581 / 309614
FastPAD 2 max power assembly 309635
VISIOPAD screen card 309636
LED strip 309638
VISIOPAD coder 309644
FastPAD 2 screen / FastPAD 2 Max UL relay connection 309646 / 309663
Safety box 577DBC 310324
Motorised valve 1" 230V 50/60 Hz female 314360
Pump 220/240V 50HZ 314373
FHKUC flow meter 314381
Heating e immersion heater gasket 366461
Door stop 366572
Synthetic filter 386087