DISHWASHER INO 81 Code NU271706-02/04
Chap. 3 – Page 2
3.2. AT THE BEGINNING OF THE SERVICE, MAKE SURE THAT:
•
The supply of rinsing product is sufficient.
•
The water inlet valve is opened.
•
The drainage control knob POS. 7 (option) is in the OUT position.
•
The filters and the overflow tube are properly installed.
3.2.1. DOSER OF RINSING PRODUCT.
- Located behind the right side panel.
- The dosing device of tensio-active product is factory-adjusted. It is possible to
modify the adjustment by actuating the adjustment screw of the dosing device.
(See the sketch on left).
- Screw up to reduce the quantity injected;
- Unscrew to increase the quantity injected.
- Make a first adjustment according to the recommendations of the product
manufacturer.
- Correct if necessary depending on the results obtained with the dishes washed.
NOTE
: To prime the dosing unit quickly, activate the adjustment screw with
a few pumping movements (afterwards, so as to avoid unpriming of the
dosing unit by lack of product in the receiver, check the product level).
3.2.2. FILTERS AND OVERFLOW TUBE.
Tube surverse
Filtre intermédiaire
Filtre inférieur
Filtre supérieur
Doser
Adjustment screw
Upper filter
Intermediate filter
Lower filter
Overflow tube
