DISHWASHER INO 81 Code NU271706-02/04
Chap. 2 – Page 3
Minimum 15 mm
Drainage connection
Drainage pump option:
When connecting the drainage flexible hose, take the following precautions:
•
The bend in the flexible hose must be located between
800 to 1000 mm
above the floor.
•
The endings of the flexible hose must be above the water level
in the tank.
•
The length of the flexible hose must be adjusted
so as to reduce the load loss and the creation
of a trap.
•
The network / flexible hose drainage link MUST NOT BE WATERTIGHT.
The diagram above is valid for dishwashers with hood and front opening.
Because drainage of the tank is by gravity, evacuation must be located at a low level at the bottom of
the tank.
In case of evacuation to the wall for the dishwashers equipped with a drainage pump, make sure the
height of the drainage connection is included within at least 0.80 m and 1 metre maximum above the
ground.
Under 0.80 metre, the tank may empty by itself.
NOTE
: See the diagram above.
Connection of detergent products
No opening of the tank can be drilled above electrical systems.
In no case must the electrical connection hinder the functioning of the dishwasher, allow for an auxiliary
relay to isolate the solenoid valve of the dosing unit.
See the assembly instructions NM14001 attached.
Height 800 to 1000
Water level in
the tank
(filling)
Floor
Drainage system
Flexible drainage hose
