bonitron M3528M4, Customer Reference Manual

Page: 11 / 24

User’s Manual
11
3.
I
NSTALLATION
I
NSTRUCTIONS
CAUTION!
Installation and/or removal of this product should only be performed by a
qualified electrician in accordance with National Electrical Code or local codes
and regulations.
Proper installation of the Model M3528M4 Battery Voltage Monitor Module should be
accomplished following the steps outlined below. Please direct all installation and start up
inquiries regarding this product to your supplier or system integrator.
3.1.
E
NVIRONMENT
The installation site should be dry and clean without extreme temperatures.
3.2.
U
NPACKING
Upon receipt of this product, please verify that the product received matches the product
that was ordered and that there is no obvious physical damage to the unit. If the wrong
product was received or the product is damaged in any way, please contact the supplier
from which the product was purchased.
3.3.
W
IRING AND
C
USTOMER
C
ONNECTIONS
This section provides information about the field connection of the batteries and signal inputs
to the M3528M4 Voltage Monitor Module.
Be sure to review all pertinent system documentation as well as the power wiring information
in Section 3.4.1 before proceeding.
Refer to Table 3-1 for the maximum wire size accepted by the individual field connection
terminals. Wire types and sizes should be chosen in accordance with national and local
electrical codes to meet the voltage and current levels present for your application.
Figure 3-1 shows a typical interconnection of the M3528M4 with a DC voltage source and
I/O signals.