bonitron M3460UC, Customer Reference Manual

Page: 14 / 56

M3460
14
3.4. W
IRING AND
U
SER
C
ONNECTIONS
Review this entire section before attempting to wire the M3460.
3.4.1. P
OWER
W
IRING
DANGER!
T
HE
M3460
CAN HAVE MULTIPLE POWER SOURCES
,
INCLUDING THE MAIN
AC
INPUT
,
ENERGY STORAGE SYSTEMS AND THE
DC
CONNECTION TO THE
VFD.
E
NSURE THAT ALL SOURCES ARE DISCONNECTED AND LOCKED OUT BEFORE
ATTEMPTING SERVICE OR INSTALLATION
.
FAILURE TO HEED THESE WARNINGS MAY RESULT IN SERIOUS INJURY
OR DEATH!
This section provides information pertaining to the field wiring connections of
the M3460. Actual connection points and terminal numbers of the AC drive
system will be found in the documentation provided with the drive system.
Be sure to review all pertinent AC drive system documentation as well as the
connection details listed below before proceeding.
Table 3-1: M3460UC Power Wiring Connections
T
ERMINAL
D
ESIGNATION
F
UNCTION
W
IRING
S
PECIFICATION
C
ONNECTION
T
ORQUE
Storage Bus
+ -
DC Input 600 VAC 3/8" stud 150 lb-in
Drive Bus
+ -
DC Output 600 VAC 3/8" stud 150 lb-in
Ground 600 VAC 5/16" stud 75 lb-in
Main power connections should be made with copper wire; use compression
fitting lugs. Wire sizing should be appropriate for the current being carried.
System ratings are listed in Section 6.1.
M3460 ride-thru units only provide full currents for a limited amount of time.
Therefore, wire heating is not as much a concern as mechanical strength.