BONFIGLIOLI active cube 201, Operating Instructions Manual

Page: 179 / 285

12/16 Operating Instructions ACU 179
16.3.2 Setting Frequency
If Operation Mode 4 - “Setting Frequency” is selected for a digital output , the relevant output will
be active once the actual value
Stator Frequency
210 is higher than the value of
Setting Frequency
510 .
The output will be switched again once the
Stator Frequency
210 drops below the value “
Setting
Frequency
510 minus
Setting Frequency Off Delta
517 ”. Once the output stages are switched off
(e.g. via STO), the digital signal “Setting Frequency” is set to zero, regardless of the actual
frequency.
Signal source 164 - "Setting frequency" can be linked to the functions of the frequency inverter.
Parameter Setting
No. Description Min. Max. Factory setting
510 Setting Frequency 0.00 Hz 599.00 Hz 3.00 Hz
517 Setting Frequency Off Delta 0.00 Hz 599.00 Hz 2.00 Hz
Once
Setting Frequency Off Delta
517 >
Setting Frequency
510 , the output will not
turned off anymore after first activation. Make sure you use suitable values during
parameterization.
Op. Mode Digital Output 1
530
or
4 - Setting frequency
Op. Mode Digital Output 2
531
or
Op. Mode Digital Output 3
532
With extension module:
Op. Mode EM-S1OUTD
533
or
Op. Mode EM-S1OUTD
534
Setting Frequency510
set value [Hz].
For linking to functions 164 - Setting frequency
Stator Frequency
210
t
Digital output
164 - Setting Frequency
Setting Frequency Off Delta
517
Setting Frequency
510