1
Assembly and Instructions
Notes:
1. Choose an appropriate location for your fountain.
2. While fountain is designed to operate as splash free as possible, some water
splashing out of the fountain is inevitable. Place your fountain in a location where any
splashing will not cause damage.
3. The National Electric Code requires that a ground fault circuit interrupter (GFCI) be
used in the branch circuit supplying fountain pump and other pond equipment. See
your electrical supplies dealer for this device.
4. Keep your fountain full of water and clean of debris and dirt to ensure proper
functioning of the pump.
5. If necessary, clean your fountain with a soft cloth and change the water frequently.
Due to water evaporation, you may see a buildup of white residue on the fountain
surface from mineral content in the water supply. To prevent such buildup, regularly
clean your fountain with soap and water, do not use any abrasive, which may damage
the applied finish.
6. See the pump instructions for pump safety, maintenance, and warranty information.
Installation & Assembly
1. Place your fountain on a level surface, away from areas where it is likely to get
clogged with leaves and make sure the fountain can get the power conveniently.
2. Connect the flexible hose to pump outlet and position the pump in the bottom of the
reservoir. Then close the cover.
4. Fill your fountain with water as the picture 2-3 shown and take a note of level that the
water reaches for future reference.
5. Plug in and switch on, after a short while the water will start to flow.
6. Adjust the pump flow rate to achieve the desired effect and to minimize any splashing.
Splashing can occur if the flow rate is too high or the reservoir is too full. The flow rate
can be increased or decreased by moving the flow rate control slider on the pump body.
Moving the switch towards ‘+’ will increase the flow rate and moving it towards ‘-’ will
decrease it.
Troubleshooting
1. If pump does not run, check the circuit breaker, try another outlet.
2. Check the water level in the fountain. Running the pump without sufficient water can
damage the pump.
