3 Safety instructions
bon E-50
3 Safety instructions
Please follow the legal requirements on accident prevention and observe the following safety instructions!
Setting-up and installation:
The refraction unit should not be assembled and operated in damp rooms.
Ensure that the device is on a level and stable surface during assembly.
Do not use the openings of the unit as carry handles! Hold the unit only by its base!
The mains voltage must be the same as stated on the product label.
The maximum load-bearing capacity of the adjustable table (2) is 40kg, or max. 25kg when it is in
position 1.
Operation:
Do not subject the device to any extremes of temperature. It is recommended that the product be used at
temperatures of b10° C and +40°C.
Avoid dropping or splashing water on the device
The maximum load-bearing capacity of the patient’s chair (3) is 170kg and should not be exceeded.
The lifting column of the patient’s chair is not designed for extended use. After being used for 60
seconds, the lifting column must be left to cool for 9 minutes.
Ensure that the adjustable table (2) does not collide with the patient’s legs when the patient’s chair (3) is
being moved upwards.
Do not sit on the moveable table (2). Avoid placing unnecessary weight on it, such as leaning on it.
Do not place your hands into the openings of the refraction unit. They could be injured or crushed!
Other information:
Do not pull on the cable in order to remove the plug from the power point.
Ensure that the cable cannot be stepped on or tripped over. Ensure that no other damage occurs to the
cable (e.g. sharp edges, high heat)
Disconnect the apparatus from the mains during repair and maintenance.
(1)Projector column
(2) Adjustable table
(3) Patient’s chair
(4) Phoropter arm
1
1
Position 2 Adjustable table
Fig. 3-1: Refraction unit bon E-50
GA bon E-50 Rev 1.0 E 211005.doc
6/15
