Section 09
BODY/FRAME
Subsection 02
(BODY)
09-02-2
MMR2004-142_09_02A.FM
Skandic LT/SWT/WT LC/SUV 550/SUV 600
If headlamp bulb is burnt, tilt hood.
Remove latches retaining plastic cover. Temporary
reinstall the top two latches to retain windshield
during bulb replacement.
1. Latches
2. Plastic cover
3. Retaining nut and screw
4. Headlamp height adjustment knob
CAUTION:
Never touch glass portion of an halo-
gen bulb with bare fingers, as it shortens its op-
erating life. If by mistake glass is touched, clean
it with isopropyl alcohol which will not leave a
film on the bulb.
DECAL
To remove a decal; heat old decal with a heat gun
and peel off slowly.
Using isopropyl alcohol, clean the surface and dry
thoroughly.
Apply liquid soap to new decal and carefully posi-
tion the decal. Using a sponge or a squeegee, re-
move the air bubbles and surplus water working
from the center toward the edges. Allow to air dry.
CAUTION:
Do not apply isopropyl alcohol or sol-
vent directly on decals.
BELT GUARD
Disassembly and Assembly
NOTE:
For additional information (ex.: exploded
view) refer to the corresponding
Parts Catalog
.
Inspection
All Models
Check belt guard mounting bosses, clips and re-
tainers for wear.
WIRING HARNESS
CABLES
TUBING
NOTE:
Refer to proper
Parts Catalog
to find suit-
able clip part numbers.
1
2
A29H16A
4
3
1
1
WARNING
Engine should be running only with belt guard
well-secured in place.
WARNING
Ensure all terminals are properly crimped on
the wires and that all connector housings are
properly fastened. Keep wires away from any
rotating, moving, heating and vibrating parts.
Use proper fastening devices as required.
WARNING
Before installation, ensure that all cables are
in perfect condition. Properly install the cable
ends and secure them in place. Pay attention
to route them properly, away from any rotat-
ing, moving, heating, or vibrating parts.
WARNING
Always ensure that the fuel, vent, primer, im-
pulse, injection oil and rotary valve oil lines
are properly fixed to their connectors, that
they are not perforated or kinked and that
they are properly routed away from any rotat-
ing, moving, heating or vibrating parts. Also
check for leaks. Replace if required.
Summary of Contents for ski-doo Tundra Scandic 2004 Series
