BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual

Page: 402 / 427

Section 09 BODY/FRAME
Subsection 02 (BODY)
MMR2004-142_09_02A.FM
09-02-1
BODY 0
INSTALLATION AND
ADJUSTMENT
HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam
is 25 mm (1 in) below the headlamp horizontal cen-
ter line, scribed on a test surface, 381 cm (12 ft 6 in)
away.
Measure headlamp center distance from ground.
Scribe a line at this height on test surface (wall or
screen). Light beam center should be 25 mm (1 in)
below scribed line.
1. Headlamp center line
A. 381 cm (12 ft 6 in)
B. 25 mm (1 in) below center line
1. Headlamp horizontal
2. Light beam (high beam) (projected on the wall)
3. Light beam center
A. 25 mm (1 in)
Required Conditions
Place the vehicle on a flat surface perpendicular to
test surface (wall or screen) and 381 cm (12 ft 6 in)
away from it.
Rider or equivalent weight must be on the vehicle.
Select high beam.
BULB REPLACEMENT
Tundra
If headlamp is burnt, tilt hood. Unplug connector
from headlamp. Remove protector cap and unfas-
ten bulb retainer clips. Detach bulb and replace.
TYPICAL
1. Retainers clips
Skandic LT/LT E
If headlamp bulb is burnt, tilt cab and unplug the
connector from the headlamp. Remove the rubber
boot and unfasten the bulb retainer ring. Detach
the bulb and replace it with a new one. Properly
reinstall parts.
TYPICAL
1. Locking ring
If the taillight bulb is burnt, expose the bulb by re-
moving red plastic lens. To remove, unscrew the 2
retaining screws. Verify all lights after replacement.
A02E0AA
1
B
90°
A
A02E07A
2
A
1
3
1
A02E09A
A25H0JA
1