BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual

Page: 336 / 427

Section 06 ELECTRICAL
Subsection 06 (TESTING PROCEDURE)
MMR2004-134_06_06A.FM
06-06-7
Enter new calibration number and press ENTER,
following screen appears:
Simultaneously with the following operation a
transfer will occur;
Trs . At this point, be ready
to rev the engine so it won’t fall below the 2000
RPM mark when not using 9-volt adaptor.
Plug-in the desired calibration cartridge (special
red key) onto the programmer post, the following
screens will appear temporarily:
Press any key, display will show followed by next
screen:
Press MENU twice, following screen will show:
After procedure is completed, ensure engine idle
speed with engine hot is 1700 - 2100 RPM.
Stop the engine.
DUCATI TRIGGER COIL CDI
SYSTEM TESTING
Skandic WT/SWT/SUV 550
IGNITION SYSTEM TESTING
SEQUENCE
In case of ignition problems, check the following
in the prescribed order until the problem can be
solved.
1. Sparking/spark plug condition.
2. Electrical connectors.
A00A5OA
T O E N D :
P R E S S A N Y K E Y
P L U G - I N K E Y
A00A41A
T R A N S F E R
+
V E R I F Y
A00A42A
T R A N S F E R
P G M R M P E M
A30E2BA
V E R I F Y
P G M R M P E M
V E R I F Y
P G M R M P E M
O P E R A T I O N
S U C C E S S F U L L
P R E S S A N Y K E Y . . .
A00A3EA
A00A5YA
1 . T I M I N G A D J U S T
2 . E N G I N E S E R I A L #
3 . C A L I B R A T I O N
1 . C H E C K K E Y S
2 . P R O G R A M K E Y
> 3 . V E H I C L E I N F O
4 S T A R T V E H . +
A30E1XA