BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual, Page: 317 / 427

Section 06 ELECTRICAL
Subsection 04 (BATTERY)
06-04-8
MMR2004-132_06_04A.FM
Connect BLACK negative cable LAST.
Apply silicone dielectric grease (P/N 293 550 004)
on battery posts and connectors.
TYPICAL — BATTERY CONNECTION
1. Vent tube on fitting
Ensure that vent tube is not kinked or blocked then
install battery cover over battery.
Close and fasten retaining strips.
Reinstall air silencer and pulley guard.
CABLE TERMINAL INSTALLATION
Carefully strip the wire approximately to 10 mm
(1/2 in) in length, using a wire stripping tool or sharp
blade/knife.
A. 10 mm (1/2 in)
NOTE: Make sure not to cut wire strands while
stripping the wire.
Install the appropriate terminal on the wire accord-
ing to the requirement. Refer to appropriate parts
catalog.
INSTALLATION OF TERMINAL
Follow the instructions provided with the crimp plier
(P/N 529 035 730) to select the proper position of
the tool.
NOTE: Different wires require different crimp plier
settings, so make sure to follow the instruction sup-
plied with the tool.
POSITIONING THE CRIMP PLIER
Step : Press
Step : Rotate

WARNING
Battery BLACK negative cable must always
be disconnected first and connected last.

WARNING
Never charge or boost battery while installed
on vehicle.
A03H1SA
1
A32E2QA
A
A32E2RA
2
A32E2SA
1
1
2