
Section 05
TRANSMISSION
Subsection 06
(BRAKE)
MMR2004-126_05_06A.FM
05-06-7
7, Brake Pad
Models with Hydraulic Brake
After brake pads installation, brake disc must be
centered in caliper. Apply brake then check for
proper brake disc positioning.
Push on appropriate caliper piston in order to
move pad inward allowing proper brake disc posi-
tioning.
1. Brake disc not centered
2. Brake disc centered
3. Apply brake before checking
Apply brake then recheck.
1,11,12, Locking Tab, Outer Caliper
and Nut
Skandic LT
Install caliper retaining bolts.
Assemble outer caliper. Install locking tab then
nuts. Torque nuts to 24 N•m (18 lbf•ft). Bend lock-
ing tab over a flat of each nut.
5,12, Brake Cable and Nut
Insert brake cable into upper hole in brake lever
and caliper. Install nut and tighten until a few
threads exceed.
24, Upper Clamp
Models with Hydraulic Brake
Install upper clamp with its arrow pointing at front
of vehicle. Tighten to 8 N•m (71 lbf•
in
) front screw
before rear one.
TYPICAL
1. Arrow on upper clamp pointing at front of vehicle
2. Tighten front screw first
ADJUSTMENT
Brake
Models with Mechanical Brake
Fully depress brake handle several times to obtain
13 mm (1/2 in) between brake handle and handle-
bar grip when brake is fully applied.
A. 13 mm (1/2 in)
Should this adjustment be unattainable, retighten
nut
no. 12
as needed.
WARNING
At least 3 threads must exceed the elastic stop
nut.
1
A03D2KA
2
3
A03D3QB
2
1
A08G02A
A
Summary of Contents for ski-doo Tundra Scandic 2004 Series
