Section 05
TRANSMISSION
Subsection 04
(DRIVEN PULLEY)
05-04-4
MMR2004-124_05_04A.FM
2,4,5, Roller Pin, Outer Cam and Spring
Insert spring in adjusting hole no. 3 into sliding half,
as illustrated.
1. Adjusting hole no. 3
Insert other spring end in cam. Mount driven pul-
ley spring compressor (P/N 529 035 300) as in DIS-
ASSEMBLY procedure.
Push cam all the way in then install roll pin coated
with anti-seize lubricant (P/N 413 701 000).
13,14,15, Fixed Pulley Half, Brake Disc
and Screw
Install brake disc on fixed pulley half and torque
screws to 15 N•m (133 lbf•
in
).
INSTALLATION
Follow installation procedure for Tundra driven pul-
ley at beginning of this subsection.
ADJUSTMENT
11,12, Shim
NOTE:
The following adjustment must be per-
formed with a new drive belt.
For best performance, particularly at starting, top
of drive belt should be flush with top of driven pul-
ley halves.
TYPICAL
1. Belt flush with the top of the pulley halves
Shim(s)
no. 11
and
no. 12
provide belt height ad-
justment between pulley halves. Adding shims
will lower the belt in driven pulley, while removing
shims will raise the belt. Adjust properly.
Pulley Alignment and Drive Belt
Deflection
Refer to PULLEY DISTANCE AND ALIGNMENT
and DRIVE BELT to perform adjustments.
CAUTION:
Drive belt and pulley adjustments
must always be checked whenever pulleys have
been removed, replaced or disassembled.
A05D12A
1
A07E0CA
1
Summary of Contents for ski-doo Tundra Scandic 2004 Series
