BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual

Page: 162 / 427

Section 04 ENGINE
Subsection 05 (LEAK TEST AND ENGINE DIMENSION MEASUREMENT)
MMR2004-114_04_05A.FM
04-05-1
LEAK TEST AND ENGINE DIMENSION
MEASUREMENT
0
LEAK TEST
The following gives verification procedures for liq-
uid cooled engines though it also applies to fan
cooled engines. For FC engines, do not consider
information pertaining to coolant system and pump
shaft oil gear reservoir.
On FC twin-cylinder engines, each cylinder cannot
be verified individually due to leakage from one
cylinder to the other through labyrinth sleeve in
center of crankshaft.
PREPARATION
1. Remove tuned pipe.
2. Install plug over exhaust manifold.
3. Remove carburetors.
4. Insert plugs in intake rubber boots. Tighten with
clamps already there.
5. Using a hose pincher (P/N 295 000 076), block im-
pulse hose.
6. Using hose pinchers (P/N 295 000 076), block
pump shaft oil hose and lubrication nipple on PTO
side.
7. Install air pump on exhaust plug.
NOTE: If necessary, lubricate air pump piston with
mild soap.
CAUTION: Using hydrocarbon lubricant (such
as engine oil) will damage rubber seal of pump
piston.
A32C1DA
A32C1EA
A32C1FA