130
Lift rear of vehicle until track is clear of the ground. Install on a wide-
base snowmobile mechanical stand.
NOTE:
Do not release track tension.
Belt Guard Removal and Installation
NOTE:
Belt guard is purposely made slightly oversize to maintain ten-
sion on its pins and retainers preventing undue noise and vibration.
It is important that this tension be maintained when reinstalling.
1. Remove tether cord cap. Open engine compartment.
2. Open retainer to release pin then pull belt guard out of vehicle.
TYPICAL
1. Pin retainer
WARNING
Do not attempt to lift the vehicle by hand alone. Use appropriate
lifting device or have assistance to share lifting stress in order to
avoid risk of strain injuries.
WARNING
Engine should be running only when belt guard is secured in
place.
1
A32C05A
mmo2005-001b_3.fm Page 130 Friday, November 21, 2003 12:28 PM
