Section 08
ELECTRICAL SYSTEM
Subsection 08
(STARTING SYSTEM)
08-08-4
LMR2000_069_08_08.FM
Release brush wires of yoke from brush holder
no. 2
.
Remove brush holder.
1. Remove brush holder
To remove brushes from yoke
no. 1
, loosen nut
and remove washers.
1. Loosen nut and remove washers
Remove brushes.
To remove bearing and seal in end cover, release
tabs of retainer.
1. Retainer
CLEANING
CAUTION:
Yoke ass’y and drive unit assembly
must not be immersed in cleaning solvent.
Discard all O-rings.
Clean brushes and holders with a clean cloth
soaked in solvent. Brushes must be dried thor-
oughly with a clean cloth.
Blow brush holders clean using compressed air.
Remove dirt, oil or grease from commutator using
a clean cloth soaked in suitable solvent. Dry well
using a clean, dry cloth.
Clean engine ring gear teeth and drive unit (clutch).
NOTE:
Bushings or bearings must not be cleaned
with grease dissolving agents.
Immerse all metal components in cleaning solu-
tion. Dry using a clean, dry cloth.
F06H1KA
1
F06H1LA
1
WARNING
Always wear safety glasses when using com-
pressed air.
F06H1MA
1
Summary of Contents for Sea-Doo SPORTSTER LE
Page 1: ...219 100 097...
Page 122: ......
