64
Fuses
Accessories, Engine Electrical
System and Gauges
If a fuse is defective, replace by one of
the same rating.
If nothing at all is working, check main
fuses located close to battery in en-
gine compartment.
NOTE:
There are spare fuses in rubber
holders attached to the top of MPEM.
TYPICAL
1. Battery
2. Main fuses
If an accessory, engine or gauge is not
working, check its fuse condition.
Fuses for the accessories, the electrical
system of the engine(s) and the gauges
are mounted on the Multi-Purpose Elec-
tronic Module (MPEM), which is located
in the engine compartment.
TYPICAL
1. MPEM
2. Spare fuse holders
3. Top fuse block
4. Bottom fuse block
5. Locking tabs
A decal on the MPEM shows the rating,
position and identification of the fuses.
Squeeze cover locking tabs and pull
cover out to access fuses.
Use the cover tabs to remove the fuse.
1. Fuse block cover
2. Use these tabs as a fuse puller
WARNING
Do not use a higher rated fuse as
this can cause severe damage. If a
fuse has burnt out. Source of mal-
function should be determined
and connected before restarting.
See an authorized Sea-Doo sport
boat dealer for servicing.
F04H60Y
2
1
F04H61Y
2
1
3
5
4
F04H62Y
1
2
lmo2002_003a.book Page 64 Wednesday, November 14, 2001 2:39 PM
