BOMBARDIER SEA-DOO GS 5626 1998, Shop Manual

Page: 58 / 426

Section 04 ENGINE
Subsection 03 (REMOVAL AND INSTALLATION)
04-03-4
All Engines
Install a hose pincher to oil supply hoses of oil in-
jection pump and rotary valve shaft (except the
947 engine); then, disconnect hoses.
TYPICAL
1. Hose pincher (P/N 295 000 076)
Install a hose pincher to oil return hose of rotary
valve shaft (except the 947 engine); then, discon-
nect hose.
Disconnect RED positive cable from starter post.
TYPICAL
1. Disconnect RED positive cable
Carry on engine lifting then tilt engine so that it
can be removed from the body opening.
TYPICAL
CLEANING
Wipe off any spillage in bilge. Clean with a bilge
cleaner.
Clean external parts of engine.
INSTALLATION
Installation of engine in watercraft is essentially
the reverse of removal procedures. However pay
particular attention to the following.
Rubber Mount, Shim and Screw
Check tightness and condition of rubber mounts.
If they have been removed, apply Loctite 242
(blue) on screw threads. Torque screws to
25 N•m (18 lbf•ft).
-
CAUTION
Be careful not to scratch body or to hit any
component.
A01B2JB
1
F01H1JB
1
-
CAUTION
Strict adherence to this torque is important
to avoid damaging threads of aluminum in-
sert in bilge.
F01D7RA