BOMBARDIER rally 200, Operator'S Manual

Page: 90 / 130

MAINTENANCE
While reading this Operator’s Guide, remember that:

WARNING
Indicates a potential hazard that, if not avoided, could result in serious in-
jury or death.

WARNING
Unless otherwise specified, engine
should not be running for all main-
tenance procedures.
Before performing any service or
inspection operation on the vehi-
cle, wait until the engine and ex-
haust have cooled down to avoid
potential burns.

WARNING
Should removal of a locking de-
vice (e.g. lock tabs, self-locking
fasteners, etc.) be required when
undergoing
disassembly/assem-
bly, always replace with a new
one.
The following covers the maintenance
items that can be performed by the
customer if desired.
Other items
found in maintenance chart must be
performed by an authorized Bom-
bardier ATV dealer.
NOTE:
Among other things, this sec-
tion gives the procedures to replace
the liquids. Refer to LIQUIDS for pro-
cedures to check levels and refill.
Engine
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at
the same time. Oil change should be
done with a warm engine.

WARNING
The engine oil can be very hot.
Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the drain plug area.
Place a drain pan under the engine
drain plug area.
Unscrew drain plug.
V06C1WY
1
1. Oil drain plug
Allow enough time for oil to flow out
of oil filter.
Unscrew the oil filter cover.
_____________________
89