Version 1.05 / June 2008
BOMAR, spol. s r.o.
Extend 900.720
Těžební 1236/1
62700 Brno
CZECH REPUBLIC
54
8)
Screw on nuts on both eccentrics and tighten them.
9)
Insert the saw band to the guiding cube (cca 15
– 20 cm).
Secure the movable hard metal guide with scotch so, that the
saw band is pressed with guides and it is possible to move
with saw band.
10)
Set the eccentrics by means of the wrenches, the saw
band must run in the centre. Guide pulleys must not press
too much on the band, but must spin freely during the band
run.
Optimal distance between the band and the pulley is 0,05
mm.
11)
Tighten nuts on both eccentrics.
12)
Remove the testing piece of saw band from the cube
lead. Install the guiding cube on the machine .
20.3. Hard metal guides replacement
If the hard metal guides cannot be adjusted, they have to be
replaced.
ATTENTION!
Hard metal guides must be replaced
together on both guiding cubes!
1)
Disconnect the hose from the cooling agent .
2)
Release 2 screws.
3)
Release the fixative pin of the bearin g holder.
