Version 1.05 / June 2008
BOMAR, spol. s r.o.
Extend 900.720
Těžební1236/1
62700 Brno
CZECH REPUBLIC
47
1)
Release the nut of the brush. It is possible to move
with the brush. Replace the worn brush for the new
one. Tighten the nut.
2)
Set the brush to the saw band.
End of brush bristles must not reach to th e bottom of the
saw band teeth.
3)
Tighten fixing screw again.
4)
In case the brush does not turn in the right way
(driving wheel of the brush skids on driving wheel of the
saw band), fasten driving wheel of the brush by means of
screw (see arrow) to the driving wheel of the saw band.
Attention!
Do not fasten screw overmuch to avoid
damage of driving wheel of the brush. Eventually to avoid
lifetime reduction of bearings of the band drive wheel.
19.4. Adjusting of the limit switch of the saw band
stretching
The limit switch of the saw band stretching is set from the
manufacturer. Is not necessary to set it.
19.5. Saw arm lower position stop adjustment
The lower stop limits the lowest position of the saw arm. This
stop point has to be checked at least once a month. If the
lower stop point is wrongly adjusted, the cutting table can be
deeply cut or the material will not be cut completely.
1)
Lift the saw frame to the top position.
2)
Release the nut of the screw and set it on the desired
value.
3)
Secure the screw with nut again.
4)
Set the limit switch of the saw frame lower position.
19.6. Limit switch adjustment of the saw frame
lower position
If we had adjusted lower stop point of the saw frame, the
limit switch adjustment inspection is re quired.
