24
•
Defrost (model dependent) and clean the appli-
ance thoroughly (see
”Cleaning and Mainte-
nance”
).
•
Leave open the appliance door to avoid formation
of mold and unpleased odors.
Tips for Energy saving
•
Disconnect the appliance from the power supply if
it isn’t in use.
•
Do not install the appliance near stoves, heaters
or other heat sources. In case of higher ambient
temperatures, the compressor will run more fre-
quently and longer.
•
Ensure enough ventilation at the bottom and rear
side. Never block ventilation openings.
•
Place all shelves, racks or drawers (depending on
the model) in their original position.
•
Adjust the temperature not colder than necessary.
•
Allow warm food to cool before placing it in the
appliance.
•
Open the appliance door only as necessary.
•
Defrost the unit regularly (model dependent).
•
The seal of the appliance door must be complete-
ly intact, so that the door closes properly.
Cleaning and Maintenance
WARNING:
•
Always disconnect the appliance from the power
supply before cleaning and user maintenance.
•
Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Hot steam could damage
the plastic parts.
•
The unit must be dry before restarting operation.
CAUTION:
•
Do not use a wire brush or other sharp, abrasive
items.
•
Do not use any acidic or abrasive detergents.
•
Do not damage the refrigerant circuit.
Cleaning the appliance including interior
•
Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfiber cloth without cleaning agent.
•
Remove the appliance content and storage it at a
cool location.
•
Clean the thaw water discharge channel / opening
carefully e.g. with a pipe cleaner.
•
After everything was thoroughly dried, you can
restart the operation.
•
Depending on model:
Wipe at least once a year
the dust that has accumulated on the appliance
back and condenser (metal grille). To do this, use
a soft brush or a vacuum cleaner.
Defrosting
CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator, it can be damaged.
The fridge has a semi-automatic defrosting system.
During defrosting water drops drains off at the back
of the cooling chamber. The thaw water running
through a channel, is collected in a drip tray located
on the compressor, where it will evaporate. Make
sure the water discharge opening does not get
clogged. A light formation of ice on the interior back
during operation is normal.
A permanently high-power level can lead to in-
creased ice formation. In this case, the fridge can be
defrosted manually
→ set a lower power level.
To achieve better cooling and to save energy, defrost
the freezer manually regularly as follows:
•
To start the defrosting process, disconnect the
appliance from the power supply.
•
Remove the food items and keep covered at a
cool location.