14
Problem
Problem
Problem
Problem
Possible cause
Possible cause
Possible cause
Possible cause
Solution
Solution
Solution
Solution
The device is not
working properly
or at all.
Are the ventilation openings clear of
obstruction?
Unblock the ventilation openings, install the
device freely.
Device cools too
much.
Is the temperature control set properly? Check the temperature setting.
The food is too
warm.
Is the temperature control set properly? Check the temperature setting.
Was the door open for an extended
period?
Open the door only as long as necessary.
Was large quantity of warm food placed
in the appliances within the last 24
hours?
Turn the control panel to a colder setting
temporally.
The appliance is near a heat source.
Check the installation location (see “Instal-
lation”).
Loud noise during
operation.
Does the device not stand vertical or
horizontal?
Adjust the feet accordingly.
Liquid flow sounds in the cooling circuit are
normal.
Water on the bot-
tom.
Is the temperature control set properly? Check the temperature setting.
Is the water discharge opening
blocked?
Clean the water discharge opening with a
pipe cleaner or knitting needle.
Light does not
work.
Is the unit not connected to mains pow-
er?
Is the light bulb defect?
Insert the plug properly in the contact
socket. Check the fuse.
Contact a specialist (see “LED light”).
The sides of hous-
ing becomes
warmly.
The device is not equipped with the conventional grating on the back. The
refrigeration cycle takes place in the foaming. The heat exchangers are installed
in the housing covered. The device does not generate cold, but cut the interior
heat. This heat must be dissipated through the housing areas.
Water on the outer
surface.
On days of high humidity, condensation might occur on the outer surface of the
device. This is no malfunction; you may simply wipe the water off.
NOTE:
NOTE:
NOTE:
NOTE:
If a problem still persists after following the steps above, please contact your distributor or an author-
ized technician.