BOMANN GSP 855, Instruction Manual

Page: 7 / 24

7
Connect the water Connect the water Connect the water Connect the water inlet inlet inlet inlet hose (cold water connection) hose (cold water connection) hose (cold water connection) hose (cold water connection)
NOTE
NOTE NOTE
NOTE::::
The water pressure must be between 0.04 and 1 MPa. With higher pressure: use a pressure regulator.
•
Connect the water inlet hose to a water thread with ¾“. Screw the hose firmly in the direction
of the screw thread; pay attention for a tight fit.
•
Connect the other end of the inlet hose to the inlet valve on the appliance back; pay attention
for a tight fit too.
Hot water supply Hot water supply Hot water supply Hot water supply
The dishwasher can be supplied with a water temperature of not more than 60°C. Supplying the appliance
with hot water, the rinse running time is shortened but the cleaning effect can be slightly reduced. The con-
nection to the hot water valve must be done in the same manner as described for the cold water connection.
Connect the water drain hose Connect the water drain hose Connect the water drain hose Connect the water drain hose
NOTE
NOTE NOTE
NOTE::::
The drain hose has a length of approx. 1.5 m and can extend with a suitable hose and connecting piece to a
length of max. 4 m.
CAUTION CAUTION CAUTION CAUTION::::
In order to prevent backflow of contaminated water, the free end of the hose must not come under the water
level of the drain.
•
Connect the drain hose to a drain pipe with a minimum diameter of
Ø 40 mm; alternatively the drain hose can be fixed directly to a sink.
•
Always make sure that the hose is not bent or squeezed.
•
It is allowed to install the hose maximal up to a height of 1000 mm above
the rinsing floor.
•
Attach the drain hose securely in order to avoid a change in position and
with it a water leakage.
Electrical connection
Electrical connection Electrical connection
Electrical connection
WARNING: WARNING: WARNING: WARNING:
•
The installation to the mains supply must conform to the local standards and regulations.
•
Improper connection may cause to an electric shock electric shock electric shock electric shock!
•
Do not use multiple sockets or extension cords.
•
It is not allowed to modify the plug provided with the appliance. If the plug does not fit properly to the outlet,
let install a proper outlet by an authorized specialist.
•
The accessibility of the power plug must always be ensured in order to disconnect the device from the
power supply in case of an emergency.
•
Ensure that your mains power corresponds with the specifications of the appliance. The specifications are
printed on the rating label.
•
Connect the mains cable to a properly installed and earthed wall outlet.