Bolt VS-560N, User Manual

Page: 33 / 44

Using Your VS-560N as a Wireless Manual Flash
|
33
groups A through C, and then channel 2, groups A through
C, and so on. The numbers represent the channel, while the
letters represent the group.
A. When using a single flash, set it to the same group and
channel as the master.
B. When using multiple flash units, select the same group
and channel for all units being used in a particular light
position. For example, if you are using three VS-560N
units, you might want to set two as a main light on channel 1, group A and set the third as a fill light
on channel 1, group B.
5. If desired, adjust the flash coverage angle by pressing the Zoom button repeatedly.
6. Make sure that the red light on the front of the flash is flashing. This indicates that the unit is ready to fire
in wireless TTL slave mode.
Using Your VS-560N as a Wireless Manual Flash
For even greater creative control, you can set the output levels of your remote flash units manually.
GROUP B