to listen to the output in order to make the adjustment.
1. Enter programming mode and press the NEXT or BACK buttons until
AUX MUTE appears on the display.
2. Press ENT to enter the function. The display shows the current amp-
input combination and a two-digit number representing the volume level
of the muted input. The default is 00 (total muting) and can be adjusted
to 25 (no muting).
3. Select the desired amp-input combination and also a paging mic.
4. Make a page with the microphone (or telephone input) and use the
arrow buttons to adjust the Aux source to the desired level. If the Aux
Mute level is set to 00 the program will be completely muted.
Note:
The mic level for adjusting this feature is set at its preset
level for the mic and amp
combination.
5.
Press ENT to store the level. The
PROG LED will blink to indicate
that data was stored
6.
Repeat steps 3, 4, and 5 for addi-
tional inputs/amplifiers and mics.
7.
Once the Aux Mute function has
been set for all inputs on all amps, press EXIT to return to the function
menu. You can exit the programming mode or press NEXT or BACK to
select another function.
Note:
The Aux Mute level will only decrease the Aux output
level when a page is made. If set higher than the current user
volume level or the Vol Limit level, no change in level will occur.
Programming
Amplifier Link
This function disconnects the power amplifier input from the preamp pro-
cessing circuit and permits the addition of outboard signal processing equip-
ment (such as an equalizer or ambient noise response unit) to the Audio
Process RCA connectors on the rear of the amplifier chassis. The link is
illustrated graphically below:
1. Enter programming mode and press the NEXT or BACK buttons until
AMP LINK appears on the display.
31
A1/AUXA 00
5003-01.QXD 8/14/00 4:46 PM Page 35