30
can be from 0.1 to 20 and sets how wide to either side
of the selected frequency the adjacent frequencies are
affected.
Q is the Quality or Quality Factor which refers to the
bandwidth of one band of a parametric equalizer. Q is
calculated by dividing the center frequency in Hz by the
width of the boost or cut zone +3 dB or -3 dB above or
below 0 dB.
Step 6
For each frequency, use the
Gain
knob or double-click
the knob and type the gain to either boost (turn up_ or
cut (turn down).
Gain
knobs can be moved b12 or -12 dB. By
default, each knob is set at 0 dB, which means that no
frequencies are being boosted or cut.
Step 7
Select
Save Settings to Server
.
6.13
Adjusting Router Settings
Router settings allow you to manipulate signal gain settings in the
DSP. The Router is also used to adjust the mix of audio to each
output of the appliance. You can access the Router page from the
drop-down menus of each channel, but only one router exists for the
appliance.
