BodyCraft Cable Pull Station, Assembly And Operating Instructions Manual

Page: 16 / 30

Cable Pull Station
16
STEP 4 Install Cable 2/2
P6
Continuing from Step P5, install pulley (19) by halfway removing 3/8“ X 3“ hex bolt (41). Be careful
to keep the pulley and the cable located next to it in place. Secure with one 3/8“ nylon nut (59) as
shown in block P6.
P7
Install the pulley (19) by halfway removing 3/8“ X 3“ the hex bolt (41) being careful to keep the pulley
and the cable located next to it in place. Secure with one 3/8“ nylon nut (59) as shown in block P7.
P8
Install one pulley (19) each using one 3/“ X 1-3/4“ hex bolt (43) and one 3/8“ nylon nut (59) as shown.
P9, P10
Install two pulleys (19) using one 3/“ X 1-3/4“ hex bolt (43) and one 3/8“ nylon nut (59) as shown.
P11 Install two pulleys
(19) using two 3/8“ X
1-3/4“hex bolts (43) and
two 3/8“ nylon nuts (59)
as shown.
IMPORTANT: Adjust the
cable tension. Refer to
(Fig.1). The cable (30)
length can be adjusted
by turning the 1/2“X
1-3/4“ hex threaded
bolt (40) at the top of
the machine clockwise
to remove slack. Adjust
counterclockwise to add
slack.
The cable Installation is
complete!
TIGHTEN ALL FRAME
AND PULLEY BOLTS
NOW.